Product Description; Installation; Operation - Concept OV2010 Bedienungsanleitung

EN

PRODUCT DESCRIPTION

1 Air outlet
2 LED humidity indicator
3 Control panel
4 Handle
5 Casters
6 Air inlet
7 Outlet for continuous drainage
8 Charger
9 Filters
10 Water tank
1
2
6
7
8
56

INSTALLATION

In order for the dehumidifier to work efficiently, the recommended
distance must be observed, as shown in the figure.
If the operating noises of the dehumidifier interfere with TV or
radio, place the unit at least 70 cm from the device

OPERATION

DEFROSTING
• Frost may form on the inside of the dehumidifier. The appliance
3
is therefore equipped with an automatic defrost function.
4
• If the appliance is located in a room with a temperature between
5 and 12 °C, the automatic defrosting will start every 30 minutes.
• If the appliance is located in a room with a temperature between
12 and 20 °C, the automatic defrosting will start every 45 minutes.
• The dehumidifier stops the operation temporarily while
defrosting.
• Do not disconnect the plug from the socket and do not turn the unit off until defrosting is done.
• This type of dehumidifier is not suitable for lowering humidity to very low level (about 30 %).
• The model is suitable for removing unpleasant moisture in everyday life and as an auxiliary device for drying wet
laundry. It is not suitable for lowering humidity to very low levels.
CONTROL
5
Control description
9
10
OV2010 OV2010
.
Power button
Press the button to turn the appliance on. Press again to turn the appliance off.
"Mode" button
Used to switch between modes. The selected mode is always indicated by the LED
next to the button.
SMART mode
Air dehumidification mode. The default mode setting is 55 % of humidity in the
room. However, you can adjust this value with the up and down buttons.
FAN mode
Air purification mode. The appliance does not dehumidify the air, but cleans it
with a HEPA filter and a carbon filter.
EN
57