Preparing For Installation - m-e VISTUS AD Betriebsanleitung

VISTUS AD | ENGLISH
INTRODUCTION
Thank you for choosing the VISTUS Video intercom system.
You have purchased a high quality system.
The assembly should be carried out by a specialist.
Care Information
Wipe the casing with a slightly damp cloth. Do not use aggressive
cleaning materials.
Legend
Outdoor station
A.2= Loudspeaker
A.3= Nameplates /Bell button
A.4= Microphone
A.5= Casing screws
A.6= Brightness sensor
Indoor station
B. 3= Mute button
GB
B. 4= Key button
B. 5= Microphone
B. 6= Talk button
B. 7= Internal button
B.11= Melody
B.12= Volume +
B.13= Volume -
B.14= Casing back
B.15= Snap fastener
B.16 = SD card slot
Scope of delivery VISTUS AD ALU-4010
1x Outdoor station with one bell button
1x Indoor station
1x Power supply ST-1000
1x Assembly materials
Scope of delivery VISTUS AD ALO-4020
1x Outdoor station with two bell buttons
2x Indoor station
1x Power supply ST-1000
1x Assembly materials
VISTUS AD-400 I-M 210x240 2019 Fin19.indd 14
Scope of delivery VISTUS AD ALU-4030
1x Outdoor station with three bell buttons
3x Indoor station
1x Power supply ST-1000
1x Assembly materials
Scope of delivery VISTUS AD-400
1x Indoor station
1x Assembly materials
Scope of delivery VISTUS AD ALU-410
1x Outdoor station with one bell button
1x Assembly materials
Scope of delivery VISTUS AD ALU-420
1x Outdoor station with two bell buttons
1x Assembly materials
Scope of delivery VISTUS AD ALU-430
1x Outdoor station with three bell buttons
1x Assembly materials

PREPARING FOR INSTALLATION

The following lines are required:
Single-family house: 3 lines from the outdoor unit to the indoor unit
and 2 lines from the outdoor unit to the door opener.
Two- and three-family house: Here 3 lines are required per bell
button from the outdoor unit into each residential unit as well
as 2 lines from the outdoor unit to the door opener.
NOTE: A wiring plan can be found in the affix.
Up to four indoor units can be connected in parallel per residential unit.
The connection can be laid as
1. Serial connections (from indoor station to indoor station) or as
2. Radial connections (parallel) from one central point
(distribution box).
The wiring plan in the affix is base on a radial wiring
system as this is preferable.
The lines should be laid in such a way that each is fed out of the wall
directly behind the corresponding outdoor/indoor unit.
14
05.12.19 15:59