Optional Accessories - Makita HK0500 Bedienungsanleitung

Bit angle
► Fig.5: 1. Change ring
The bit can be secured at 12 different angles. To
change the bit angle, slide the change ring forward,
then turn the change ring to change the bit angle. At the
desired angle, slide the change ring back to the original
position. The bit will be secured in place.
OPERATION
► Fig.6: 1. Scaling chisel 2. Tile
Position the bit at the location to be chipped, then pull the
switch trigger. Apply slight pressure on the tool so that the
tool will not bounce around, uncontrolled. Pressing very
hard on the tool will not increase the efficiency.
NOTE:
• When removing tiles with a scaling chisel, apply
the chisel to the bottom of tiles as shown in the
figure. If you operate the tool with the chisel
applied to the top surface of tiles, the service life
of the chisel will be shortened.
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and unplugged
before attempting to perform inspection or maintenance.
• Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation or cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, carbon brush inspection and replacement, any
other maintenance or adjustment should be performed
by Makita Authorized Service Centers, always using
Makita replacement parts.

OPTIONAL ACCESSORIES

CAUTION:
• These accessories or attachments are recom-
mended for use with your Makita tool specified
in this manual. The use of any other accessories
or attachments might present a risk of injury to
persons. Only use accessory or attachment for
its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
• Bull point
• Cold chisel
• Scaling chisel
• Safety goggles
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
5 ENGLISH