Makita DTD134 Bedienungsanleitung Seite 8

OPERATION
► Fig.12
The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. The relation between fas-
tening torque and fastening time is shown in the figures.
Standard bolt
N m
(kgf cm)
120
(1,224)
100
(1,020)
80
(816)
60
(612)
40
(408)
M8
20
(204)
0 1.0
Fastening time (S)
M14
M12
(M14)
M10
(M12)
(M10)
(M8)
2.0 3.0
High tensile bolt
N m
(kgf cm)
120
(1,224)
100
(1,020)
80
(816)
60
(612)
40
(408)
20
(204)
0
Fastening time (S)
Hold the tool firmly and place the point of the driver bit
in the screw head. Apply forward pressure to the tool to
the extent that the bit will not slip off the screw and turn
the tool on to start operation.
NOTE:
• Use the proper bit for the head of the screw/bolt
that you wish to use.
• When fastening screw M8 or smaller, carefully
adjust pressure on the switch trigger so that the
screw is not damaged.
• Hold the tool pointed straight at the screw.
• If you tighten the screw for a time longer than
shown in the figures, the screw or the point of
the driver bit may be overstressed, stripped,
damaged, etc. Before starting your job, always
perform a test operation to determine the proper
fastening time for your screw.
• If you use a spare battery to continue the opera-
tion, rest the tool at least 15 min.
The fastening torque is affected by a wide variety of
factors including the following. After fastening, always
check the torque with a torque wrench.
1. When the battery cartridge is discharged almost
completely, voltage will drop and the fastening
torque will be reduced.
2. Driver bit or socket bit
Failure to use the correct size driver bit or socket
bit will cause a reduction in the fastening torque.
3. Bolt
• Even though the torque coefficient and the
class of bolt are the same, the proper fasten-
ing torque will differ according to the diame-
ter of bolt.
8 ENGLISH
M12
(M12)
M10
(M10)
M8
(M8)
1.0 2.0 3.0