Victron energy BMV-700 Anleitung Seite 10

Consumed Amp-hours
Example:
If a current of 12A is drawn from a fully charged battery for a period of 3
hours, this readout will show -36.0Ah.
(-12 x 3 = -36)
Note:
Three dashes '---' will be shown when the BMV is started in
unsynchronised state. See section 4.2.1, setting number 70.
State of charge
Note:
Three dashes '---' will be shown when the BMV is started in
unsynchronised state. See section 4.2.1, setting number 70.
Time-to-go
The time-to-go displayed is the time to reach the discharge floor.
See 4.2.2, setting number 16.
Note:
Three dashes '---' will be shown when the BMV is started in
unsynchronised state. See section 4.2.1, setting number 70.
8
The amount of Ah consumed from the
battery
A fully charged battery will be indicated by a
value of 100.0%. A fully discharged battery
will be indicated by a value of 0.0%.
An estimation of how long the battery can
support the present load until it needs
recharging.