Haier HWD80-BP14636N Bedienungsanleitung Seite 7

EN
Installation
▶ Ensure a location which allows opening the door fully. Do not in-
stall the appliance behind a lockable door, a sliding door or a door
with hinges on the opposite side of the appliance door as this lim-
its the full opening of the appliance door.
▶ The appliance should be placed in a well-ventilated place. Ensure
a location which allows opening the door fully.
▶ Never install the appliance outdoors in a damp place, or in an area
which may be prone to water leaks such as under or near a sink
unit. In the event of a water leak cut power supply and allow the
machine to dry naturally.
▶ Install or use the appliance only where the temperature is above 5 °C.
▶ Do not place the appliance directly on a carpet, or close to a wall
or furniture.
▶ Do not expose the appliance to any frost, heat or direct sunlight
or in the near of heat sources(e.g. stoves, heaters).
▶ Make sure that the electrical information on the rating plate
agrees with the power supply. If it does not, contact an electri-
cian.
▶ Do not use multi-plug adapters and extension cables.
▶ Make sure only the delivered electric cable and hose set are used.
▶ Make sure not to damage the electric cable and the plug. If dam-
aged have it replaced by an electrician.
▶ Use a separate earthed socket for the power supply which is easy
accessible after installation. The appliance must be earthed.
Only for UK: The appliance's power cable is fitted with 3-cord
(grounding) plug that fits a standard 3-cord (grounded) socket.
Never cut off or dismount the third pin (grounding). After the ap-
pliance is installed, the plug should be accessible.
▶ Make sure the hose joints and connections are firm and there is
no leakage.
Intended use
This appliance is intended for washing and drying machine-washable
laundry only. Anytime follow the instructions given on the label of
each garment label. It is designed exclusively for domestic use inside
the house. It is not intended for commercial or industrial use.
Changes or modifications to the device are not allowed. Unintended
use may cause hazards and loss of of all warranty and liability claims.
1- Safety information
7