Haier HWD80-BP14636N Bedienungsanleitung Seite 30

10- Installation
10-6.1
10-6.3
CAUTION!
▶ The drain hose should not be submerged in water and should be securely fixed and
leak-free. If the drain hose is placed on the ground or if the pipe is at a height of less
than 80 cm, the washing machine will continuously drain while being filled (self-si-
phoning).
▶ Drain hose is not to be extended. If necessary contact after sales service.
10-7.1
30
Following connections are possible:
10-6.2
10.6.1 Drain hose to sink
▶
▶
10.6.2 Drain hose to waste water connection
▶
▶
▶
10.6.3 Drain hose to sink connection
▶
▶
▶
10.7 Fresh Water Connection
10-7.2
Make sure that the gaskets are inserted.
1. Connect the water inlet hose with the angled end
2. The other end connect to a water tap with a 3/4"
Hang the drain hose with the U-support over the
edge of a sink with adequate size (Fig. 10-6.1).
Protect the U-support sufficiently against slip-
ping.
The internal diameter of the stand pipe with
vent-hole must be minimum 40 mm.
Put the drain hose for approx. 80 mm in the
wastewater pipe.
Attach the U-support and secure it sufficiently
(Fig. 10-6.2).
The junction must lie above the siphon.
A spigot connection is usually closed by a pad (A).
That must be removed to prevent any disfunc-
tion (Fig. 10-6.3).
Secure the drain hose with a clamp.
to the appliance (Fig. 10-7.1). Tighten the screw
joint by hand.
thread (Fig. 10-7.2).
EN