Vehicle Charge In Dlm Mode; Rfid Operating Mode - Gewiss JOINON WALLBOX I-CON PREMIUM Installations- Und Bedienungsanleitung

12.1.2 VEHICLE CHARGE IN DLM MODE

This charging mode can be set using the "I-CON MANAGER" APP or on the graphic interface and completing the
configuration in order to:
1. Determine the type of energy meter installed upstream.
2. Set the limit power of your domestic system
As already indicated in the previous chapters, an energy meter (code GWD6812 or GWD6817) must be installed
upstream of the electrical system and it must be connected to the charging station via the RS485 line
The presence of the external energy meter connected to the charging station and the indication of the system
variables allow the station to manage charging in a completely autonomous manner, varying the power based on
the trend of the domestic electrical consumption, thereby optimising charging as much as possible.
NOTE= for 4.6 and 7.4kW single-phase stations, it is only possible to associate the single-phase energy meter
GWD6812 to ensure that the setting related to system power is congruous. The same also applies for 11kW three-
phase versions, where it will only be possible to associate the three-phase energy meter GWD6817.
To enable a recharging session:
1 Make sure there are no errors on the charging station
Insert the charging plug in the socket-outlet of the station, and in the vehicle
2 or
Connect the mobile connector to the vehicle.
The station will decide if it is possible to start the charge or if it must
3 be kept in stand-by based on the domestic consumption detected.
The user does not have to do anything
At every moment, the station decides if it is possible to continue with
4 charging, or if it must be suspended to permit domestic consumption.
There is no action or operation that the customer can perform
Charging session in progress but car battery charged
5 or
Session suspended due to an increase in domestic consumption
The charging session was ended by the customer by disconnecting
6
the cable from the vehicle
7 If the station detects no errors, it will return to standby

12.2 RFID OPERATING MODE

The station activates the charging session once a valid RFID card has been swiped.
There are two ways of adding more RFID cards to the local list:
METHOD 1
# Action to be carried out
1 Swipe the MASTER key across the RFID reader to access the secret menu From fixed green to flashing white
2 Move in the menu using the slider
reaching the item RFID CARD MEMORISATION
3
Confirm the selection with the push-button
Take each card that you want to add to the list and swipe them across
4 the RFID scanner. The colour of the RGB LED and the text on the main
display indicate correct acquisition
To exit the RFID card memorisation menu and return to the previous
5
item, wait until timeout ends.
6 Go to the EXIT item in the menu
until
Fixed green
Fixed green
Flashing blue
(charging in stand-by)
or
Fixed blue
(charging started)
Flashing blue
Flashing green
Fixed green
RGB LED / Touch Slider status
Flashing white
Flashing white/ clockwise light
effects
Fixed green for 2 seconds
From flashing white to fixed green
73