Testing The Refrigerant; Viewing The Test Results - Bacharach Neutronics LEGEND ID RI-2018 Serie Bedienungsanleitung

2.4

Testing the Refrigerant

After the air calibration is complete, the instrument is ready for testing. The analyzer will
direct you to connect the hose to a refrigerant source as shown in (Figure 7). Connect the
hose to the vehicles Low Side Schrader valve, or connect it to the Low Side Port on a
refrigerant cylinder, and open the valve. Allow the refrigerant to flow for a few seconds and
then press the 'Test' button to begin the test. The Testing screen shown in (Figure 8) will
display.
Figure 7
2.5

Viewing the Test Results

Upon completion of testing, the Legend ID™ will display (Figure 9). Disconnect the coupler
from the refrigerant source and select 'Results' to display the test results (Figure 10). The
percentage displayed for each refrigerant indicates the total purity weight of that
refrigerant, equaling 100%, with air and non-condensable gases measured independently.
Pressing 'Print' will print the test results. Pressing 'Print Prior 5 Results' will print the last 5
tests completed.
Figure 9
Manual Part Number:
5-06-7000-80-0
Figure 8
Figure 10
Manual File:
012476 Rev. A
Page 2-17