Dismantling And Disposal - Knurr Cooltherm Bedienungsanleitung

CoolTherm
Manual / Bedienungsanleitung
Step 3:
Unfix cable strap
of humidity sensor
and unscrew it
including fixing
screw.
Put the sensor
outside of the heat
exchanger
The heat exchanger is installed in the reverse order of removal.
Regularly check the condensed water drain and clean if necessary
7.

Dismantling and disposal

The CoolTherm may be dismantled by suitably qualified personnel only.
CoolTherm
Step 6:
Unfix fixing
four screws
Step 7:
Pull out heat
exchanger
Step 5:
Unfix
condensate
connection
Prior to dismantling:
Correctly shut down fans and any other electrical
-
components and disconnect from power supply!
- Secure against switch on!
- Shut down water cooling circuit and secure against
switch on.
01.998.330.0 issue / Ausgabe h
Step 4:
Unfix earth
cable
page / Seite 30/76