Troubleshooting - Makita DUR365UZ Betriebsanleitung

Hook the middle of the new nylon cord to the notch
located at the center of the spool between the 2 channels
provided for the nylon cord.
Wind both ends firmly around the spool in the direction
marked on the head for left hand direction indicated by
LH. (Fig. 30)
Wind all but about 100 mm of the cords, leaving the ends
temporarily hooked through a notch on the side of the
spool. (Fig. 31)
Mount the spool on the cover so that the grooves and
protrusions on the spool match up with those on the
cover. Now, unhook the ends of the cord from their
temporary position and feed the cords through the eyelets
to come out of the cover. (Fig. 32)
Align the protrusion on the underside of the cover with the
slots of the eyelets. Then push the cover firmly onto the
housing to secure it. Make sure the latches fully spread in
the cover. (Fig. 33)
Malfunction status
Motor does not run.
Motor stops running after a little
use.
It does not reach maximum
RPM.
Cutting tool does not rotate: stop
the machine immediately!
Abnormal vibration: stop the
machine immediately!
Cutting tool and motor cannot
stop: Remove the battery
immediately!
014837
16
Cause
Battery cartridges are not installed.
Battery problem (under voltage)
The drive system does not work
correctly.
Rotation is in reverse.
Battery's charge level is low.
Overheating.
Battery is installed improperly.
Battery power is dropping.
The drive system does not work
correctly.
Foreign object such as a branch is
jammed between the guard and the
nylon cutting head.
Cutter blade fastening nut is loose.
The cutter blade is bent.
The drive system does not work
correctly.
One end of the nylon cord has been
broken.
The cutter blade is bent, cracked or
worn.
Cutter blade fastening nut is loose.
Cutter blade is fastened improperly.
The drive system does not work
correctly.
Electric or electronic malfunction.
Replacing the blade for plastic blade
(Fig. 34)
Replace the blade when it is worn out or broken.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers, always
using Makita replacement parts.
TROUBLE SHOOTING
Before asking for repairs, conduct your own inspection
first. If you find a problem that is not explained in the
manual, do not attempt to dismantle the tool. Instead, ask
Makita Authorized Service Centers, always using Makita
replacement parts for repairs.
Install the battery cartridges.
Recharge the battery cartridge. If recharging
is not effective, replace battery cartridge.
Ask your local authorized service center for
repair.
Change the direction of ratation with the
reversing switch.
Recharge the battery cartridge. If recharging
is not effective, replace battery cartridge.
Stop using of tool to allow it to cool down.
Install the battery cartridge as described in
this manual.
Recharge the battery cartridge. If recharging
is not effective, replace battery cartridge.
Ask your local authorized service center for
repair.
Remove the foreign object.
Tighten the nut properly as described in this
manual.
Replace the cutter blade.
Ask your local authorized service center for
repair.
Bump the nylon cutting head against the
ground while it is rotating to cause the cord to
feed.
Replace the cutter blade.
Tighten the nut properly as described in this
manual.
Ask your local authorized service center for
repair.
Remove the battery cartridge and ask your
local authorized service center for repair.
Action