Before Use; Operation - cecotec VisionToast Bedienungsanleitung

cool down before cleaning.
· Be careful when taking out hot bread slices to avoid injuries.
· If the toasting slot gets stuck while the toaster is on, unplug the appliance immediately and let
it cool down before emptying and cleaning it. If the problem persists, stop using the appliance
and contact the Technical Support Service of Cecotec.
· Do not attempt to remove food from the inside of the toaster while it is plugged to the mains
supply. Unplug it and let it cool down before removing foodstuffs from its interior.
· Do not use a knife or any other sharp metal tool to remove the bread slices from its interior.
Never insert your hand inside the slot. Do not touch the metal parts inside the toaster.

2. BEFORE USE

· This product has been packaged to protect it against transportation damage. Unpack the
appliance and keep the original packaging carton and materials in a safe place. It will help
prevent any damage if the product needs to be transported in the future. In case the original
packaging is disposed of, make sure all packaging materials are recycled accordingly.
· Plastic wrapping can cause suffocation hazards for babies and young children. Make sure all
packaging materials are out of reach of children.
· Inspect all parts of the appliance for visual damage. Unwind the power cord completely and
inspect it for damage. Do not use the appliance if the toaster or its cord have been damaged or
are not working properly. In case of damage, contact the official Technical Support Service of
Cecotec for advise, repairs, or returns.
· Make sure you have read and understood all instructions and warnings in this instruction
manual. Pay particular attention to the safety instructions on previous pages.
· Remove any adhesive labels and wipe the outside of the toaster with a damp cloth. Make sure
no packaging materials remain in the toasting slot and no object has fallen inside the toaster.
· Place the toaster on an even, heat-resistant surface. Do not place the toaster near heat
sources, places with high humidity levels, or combustible materials.
· Plug the toaster into an appropriate wall outlet. The plug must be accessible so that, in case of
an emergency, it can be easily unplugged.
· Press the button ON/OFF.
· Set the toasting intensity dial to level 4, press STOP/START, and let your toaster heat up
without any bread.
NOTE: you may notice a slight burning smell or smoke when using the toaster for the first
time, caused by the excess of lubricants from the manufacturing process. Ensure good
ventilation and let the toaster complete a few cycles until no odour or smoke can be noticed.
· After a short cooling down period, your toaster will be ready for use. The operation instructions
are detailed below.

3. OPERATION

1. Make sure the crumb tray is properly placed before use (Fig. 1). It is located underneath the
heating elements and can be pulled out from the side of the toaster opposite to the control panel.
03042_VisionToast_Manual_LI.indd 15
ENGLISH
VisionToast 15
11/8/17 13:43