Compaq Smart Array 5300-Serie Handbuch Seite 8

UnixWare 7.x Driver Installation Procedure
A. After OS Installation
1. Log on to the server as root.
2. Insert the Smart Array 5300 Controller Support Software Diskette #2.
3. Type pkgadd -d diskette1 ciss.
4. Continue the installation using the OS instructions. Leave the diskette in the
diskette drive until you are instructed to remove it.
B. During OS Installation
NOTE: If the Smart Array 5300 will be the boot controller, please refer to Chapter 2,
"Installing the Smart Array 5300 as the Boot Controller", in the user guide. This section
contains detailed instructions on installing the Smart Array 5300 as the boot controller,
configuring a drive array, and optionally creating and populating a system partition
before installing the Operating System.
1. Start the UnixWare 7.x installation as directed by the OS instructions.
2. When prompted for an hba diskette, insert the Smart Array 5300 Controller
Support Software Diskette #2 into the diskette drive.
3. After the hba drivers are loaded, insert additional hba diskettes if required.
4. Continue the installation using the OS instructions. Leave the diskette in the
diskette drive until you are instructed to remove it.
For the most recent version of Compaq EFS, visit http://www.compaq.com/support/
files/server/us/index.html.