Compaq Smart Array 5300-Serie Handbuch Seite 3

07. The screen for specifying additional drivers will be displayed again. If you do not have
any additional drivers to install, press Enter.
08. Follow the instructions to complete the installation. Leave the diskette in the drive
until instructed to remove it.
09. Reboot.
10. Install the CISS (cpqcisse.sys) Array Notification driver.
a. Insert the Smart Array 5300 Controller Support Software CD into the
CD-ROM drive.
b. Click Start and choose Run from the menu, if autorun does not execute.
c. Enter <CD-ROM drive letter>:\Win2K\cpqsetup.exe in the Open field.
d. Click OK.
NOTE: A screen will appear stating that the software is installed and up-to-date.
At this point click the install button to continue installing the CISS ARRAY
NOTIFICATION driver.
e. Follow the on-screen instructions. Results of the installation are logged to the
<boot drive letter>:\cpqsystem\log\cpqsetup.log file.
Windows NT 4.0 Driver Installation Procedure
A. After OS Installation
1. Insert the Smart Array 5300 Controller Support Software CD into the
CD-ROM drive.
2. Click Start and choose Run from the menu, if autorun does not execute.
3. Enter <CD-ROM drive letter>:\Winnt4\cpqsetup.exe into the Open field.
4. Click OK, and follow the on-screen instructions.
Results of the installation are logged to the <boot drive letter>:\cpqsystem\
log\cpqsetup.log file.
B. During OS Installation
NOTE: If the Smart Array 5300 will be the boot controller, please refer to Chapter 2,
"Installing the Smart Array 5300 as the Boot Controller", in the user guide. This section
contains detailed instructions on installing the Smart Array 5300 as the boot controller,
configuring a drive array, and optionally creating and populating a system partition
before installing the Operating System.