Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6
Care and Maintenance
6.1
Care
● Occasionally the o-ring at the syringe adapter 12 should be lubricated with the
enclosed silicone grease. This will prolong the life.
☞
Note!
Clean hands after application of grease to assure surfaces to be bonded are clean.
Otherwise a fusion might fail.
● Clean adhesive residue from the pencil holder 18 or replace it with a new one as
required.
Warning!
If cleaning agents are not properly handled, damage to health can result!
Observe general safety regulations for the handling of chemicals!
Observe manufacturer's instructions! Request a safety data sheet for the product used!
Recommended cleaning agents for:
– Anaerobic and UV curing adhesives and chip bonder:
Cured adhesives cannot be removed with the solvents that are permitted to be used at
the present time.
Fluid adhesive residues can be removed with various solvents.
Well suited is ACETON.
– Cyanacrylate adhesives:
The best solvent is ACETON.
Supply sources for solvents:
– ACETON Local specialist dealers
6.2
Maintenance
The unit requires no special maintenance.
39
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
