Leveling The Area - Swim & Fun 2901 Handbuch

4.

Leveling the area

Attention
Take as much time as possible to work out a site that is completely firm and level.
Leveling is extremely important
Take as much time as possible to work out a site that is completely firm and level. Use a carpen-
ter's level to ensure that the site is completely level, flat and firm!. The pool contains a huge amount
of water and thousands of kilos of weight. Should the pool collapse due to unleveled ground, it
could cause a lot of damage to property and even human injury or death!
Remove the higher ground rather than filling the low laying ground.
Mounting with pelvic floor insulation:
If you cover the pelvic floor with insulation (shatter-proof), it is necessary to cover the intire pool.
Place a maximum of a 3 cm thick flat gravel layer and compress, then put the insulation into the
bottom gravel bed.
Concrete foundation:
For a concrete foundation instructions are the same, with the concrete slab replacing the gravel
bed (thickness depends on the local conditions about 15 - 20 cm with iron reinforcement).
Pool installation without floor insulation:
Concrete slabs beneath the bottom rail connectors are not essential for stability and safety, but
their installation is recommended. Otherwise, it may result in subsidence, which can damage the
pool in the sequence. The concrete slab should be recessed flush with the installation location.
Around the pool should be a free space of 1.2 meters to keep children from falling into the pool.
Attention
Always remove grass, roots and stones within the circle. Use a ground cover provided
to ensure that roots and stones doesn't penetrate the pool liner and cause damage.
116
A: Remove high spots
B: Do not fill low spots
MV-2901-2902-2903-2912-2913-2914-2915-11-2017 . © Alle rettigheder forbeholdes Swim & Fun Scandinavia ApS
UK