Fitting The Pvc Pool Liner - Swim & Fun 2901 Handbuch

7.

Fitting the PVC pool liner

Cover with some clean sand (not stones and other
debris) the bottom part with a height of about 1-2 cm
from and condense this. On the steel wall, a periph-
eral wedge is to be made in a triangular shape
(chamfer) and should not exceed 7 cm. With this
little trick you avoid that the entire water pressure
will push the liner under the metal wall. To prevent
the sand from running away, you should also affix a
plastic film along the pelvic floor as shown. (See
diagram 14)
1) Sand 2) Tape 3) Plastic film 4) Steel Wall
Tip
Leave the liner in the sun to warm the PVC up
before installation. This makes the liner much
easier to handle.
Put the liner at the center of the pool site inside the
pool wall. Extend it evenly until the seam line reach-
es the base of the pool. Drape the pool liner over
pool wall. There should be an overlap of 8 cm of the
pool wall height. (See diagram 15)
SHOES ARE NOT ALLOWED ON THE LINER
Hold the overlap in place with clips. (See diagram
16).
Note
With the liner in position, fold the remaining liner
material evenly by dividing this excessive liner
uniformly along the entire perimeter but do not
fold. (See diagram 17).
Important!
If the dimension of the PVC liner is smaller than
the steel wall, do not stretch or force the PVC!
Stop the assembly immediately and call custo-
mer service for assistance.
120
MV-2901-2902-2903-2912-2913-2914-2915-11-2017 . © Alle rettigheder forbeholdes Swim & Fun Scandinavia ApS
UK