Filling The Pool - Step 2 - Swim & Fun 2901 Handbuch

UK
screws until all are in place. Once they are in place tighten the screws diagonally and uniformly to
ensure that proper sealing is attained.
Note
To avoid overtightening, use a standard screw driver. Never use a power screw driver.
It is also important to check that the skimmer gasket is evenly mounted around the ope-
ning. Lastly, use a sharp knife to cut away the liner in the skimmer opening.
Place the basket into the skimmer housing and fix the cover. Coat the Teflon tape to the threading
of the outlet connector and then connect it to the skimmer housing.
Clip the weir to the front of the pool skimmer housing if not already assembled.
Make sure the skimmer is sealed to the pool wall and no water is leaking.
Connect the filtration system to the pool. Follow the filtration system's instructions for assembly re-
quirements before operating.

15. Filling the pool - Step 2

Before you fill the pool with water,
thoroughly check to see if there are
any loose screws, holes or tears
in the liner. Continue to fill the pool
until water reaches half way into
the skimmer box opening. The pool
is full when water reaches about
15 cm from the top of the pool wall.
(See diagram 36)
Warning!
To avoid collapse, never leave the pool without water.
MV-2901-2902-2903-2912-2913-2914-2915-11-2017 . © Alle rettigheder forbeholdes Swim & Fun Scandinavia ApS
127