Technical Data - Honeywell IDENTLOC Serie Montage, Anschluss, Anleitung

Mounting and Connection Instructions IDENTLOC Transmission Unit
3.2 Cable routing
connecting cable to the EU
possible cable bushings
(punch them through if required)
view from
the bottom
possible cable bushings
(punch them through if required)
3.3 Plug-in mounting
connecting cable to the EU
transmission unit without housing
If required, it is possible to install the transmission unit without housing in a bore with 8 mm
diameter.
ATTENTION:
Installation in metal sections (e.g. aluminum) is not possible!
3.4 Connecting the transmission unit
After successful completion of the functional check, the screw openings of the
transmission unit must be covered by means of the supplied VdS sealing stickers!
4.

Technical data

Int. protection acc.to DIN 40 050/EN 60 529
Environmental class according to VdS
Operating temperature range
Colour
VdS approval
The transmission unit 032220.17 complies with the essential requirements of the R&TTE
1999/5/EC Directive, if used for its intended use.
The EC-Declaration of Conformity can be downloaded from our homepage (Service / Download).
Depending on the mounting type, the cable
can also be guided downwards (instead of
using the lateral cable bushings).
white
shield
IP 67
III
-25 °C to +60 °C
Traffic white (similar to RAL 9016)
in combination with all VdS approved
IDENTLOC sensors
red
7