Scheppach PLC40 Original Bedienungsanleitung Seite 27

Slag formation on interfaces?
Arc stops during cutting?
Insufficient Penetration?
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Tool/material creates heat.
Cutting speed too low or current too
high.
Plasma burner component parts are
worn
Cutting speed too low.
Plasma burner is held too high and
too far away from the material.
Plasma burner component parts are
worn
Workpiece no longer connected to
the grounding cable.
Cutting speed too fast.
Burner sleeve is not straight
Metal is too thick.
Plasma burner component parts are
worn
Allow the material to cool down and then contin-
ue cutting
Increase the speed and/or reduce the current un-
til the slag has been reduced to a minimum.
Check and replace worn parts.
Increase the cutting speed until the problem no
longer exists.
Lower the plasma burner to the recommended
height.
Check and replace worn parts.
Check the connections.
Slow down the working speed
Adjust the inclination.
Several cycles necessary.
Check and replace worn parts.
GB | 27