Troubleshooting - Kenwood KDC-BT45U Bedienungsanleitung

TROUBLESHOOTING

Symptom Remedy
• Adjust the volume to the optimum level.
Sound cannot be heard.
• Check the cords and connections.
"MISWIRING CHECK WIRING Turn the power off, then check to be sure the terminals
THEN PWR ON" appears. of the speaker wires are insulated properly. Turn the
power on again.
"PROTECTING SEND Send the unit to the nearest service center.
SERVICE" appears.
• Sound cannot be heard.
Clean the connectors. ( 2)
• The unit does not turn on.
• Information shown on
the display is incorrect.
The unit does not work Reset the unit. ( 3)
at all.
• Radio reception is poor. • Connect the antenna firmly.
• Static noise while • Pull the antenna out all the way.
listening to the radio.
Press and hold M to forcibly eject the disc. Be careful
Disc cannot be ejected.
not to drop the disc when it is ejected. If this does not
solve the problem, reset the unit. ( 3)
Noise is generated. Skip to another track or change the disc.
Tracks do not play back as Playback order is determined when files are recorded.
you intended them to play.
"READING" keeps flashing. Do not use too many hierarchical levels or folders.
Elapsed playing time is not This is caused by how the tracks are recorded.
correct.
Correct characters are not This unit can only display uppercase letters, numbers,
displayed (e.g. album and a limited number of symbols. Uppercase Cyrillic
name). letters can also be displayed if [РУССКИЙ] is selected.
( 4)
18
Symptom Remedy
"NA FILE" Make sure the disc contains supported audio files. ( 17)
"NO DISC" Insert a playable disc into the loading slot.
"TOC ERROR" Make sure the disc is clean and inserted properly.
"PLEASE EJECT" Reset the unit. If this does not solve the problem, consult
your nearest service center.
"READ ERROR" Copy the files and folders onto the USB device again. If this
does not solve the problem, reset the USB device or use
another USB device.
"NO DEVICE" Connect a USB device, and change the source to USB again.
"COPY PRO" A copy-protected file is played.
"NA DEVICE" Connect a supported USB device, and check the connections.
"NO MUSIC" Connect a USB device that contains playable audio files.
• Reconnect the iPod.
"iPod ERROR"
• Reset the iPod.
• Sound cannot • Reconnect the Android device.
• If in [HAND MODE], launch any media player application
be heard during
playback. on the Android device and start playback.
• Sound output only • If in [HAND MODE], relaunch the current media player
from the Android application or use another media player application.
• Restart the Android device.
device.
• If this does not solve the problem, the connected Android
device is unable to route the audio signal to unit. ( 17)
• Make sure KENWOOD MUSIC PLAY APP is installed on the
Cannot playback at
[BROWSE MODE]. Android device. ( 7)
• Reconnect the Android device and make the appropriate
setting in [ANDROID SETUP]. ( 7)
• If this does not solve the problem, the connected Android
device does not support [BROWSE MODE]. ( 17)