Assembly - Husqvarna GX560 Bedienungsanweisung

• The exhaust fumes from the engine contain carbon
monoxide, an odourless, poisonous and very
dangerous gas. Do not start the engine indoors or in
closed spaces.
• Before you do the maintenance on the product, stop
the engine and remove the ignition cable from the
spark plug.
• Use protective gloves when you do maintenance on
the cutting equipment. The blade is very sharp and
cuts can easily occur.
• Accessories and changes to the product that are not
approved by the manufacturer, can cause serious
To assemble the lower handle
1. Put the hook attached to the handle (A) through the
center slot (B), in the direction of the arrow (C).
D
B
2. Turn the handle clockwise 90° to put the ends of the
lower handle between the brackets (D) on the cutting
cover.
3. Put the clevis pins (A) through the brackets and the
ends of the lower handle. Lock with the lockpins (B).
B
To assemble the upper handle
1. Put the lower handle in park position, see
handle position on page 8 .
2. Make sure that the choke control is on the left side of
the product when viewed from the rear.
6

Assembly

90°
A
C
A
To set the
Автотовари «130»
injury or death. Do not change the product. Always
use accessories that are approved by the
manufacturer.
• If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
• Only do the maintenance as given in this owner's
manual. All other servicing must be done by an
approved Husqvarna service agent.
• Let an approved Husqvarna service agent do
servicing on the product regularly.
• Replace damaged, worn or broken parts.
3. Align the holes in the upper handle with the holes in
the lower handle and attach the screws, washers
and knobs.
4. Use the straps to attach the cables to the handle.
CAUTION: Make sure that the tension in
the cables is not too high.
461 - 006 - 25.01.2019