Maintenance; Maintenance Schedule - Husqvarna GX560 Bedienungsanweisung

• Do not cut more than ⅓ of the length of the grass.
Cut first with the cutting height set high. Examine the
result and lower the cutting height to an applicable
level. If the grass is very long, drive slowly and cut 2
times if necessary.
Introduction
WARNING: Before you do maintenance, you
must read and understand the safety
chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
Before you do maintenance work
WARNING: To prevent injury and damage to
the product, obey these instructions when it
is necessary to put the product on its side.
1. Close the fuel valve.
2. Let the engine run until it stops.

Maintenance

Do a general inspection
Examine the oil level
Clean the product
Examine the cutting equipment
Examine the cutting cover*
Examine the engine brake handle*
Examine the air filter
Examine the muffler*
Examine the spark plug
Clean the air filter
Change the air filter
461 - 006 - 25.01.2019
• Cut in different directions each time to prevent
stripes in the lawn.
Maintenance
3. Disconnect the spark plug cable.
4. Tilt the product to its left side, with the air filter (A) up
and the muffler down.

Maintenance schedule

The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with * see instructions in
Safety devices on the product on page 5 .
Автотовари «130»
A
Daily Weekly
X
X
X
X
X
X
X
X
X
Monthly
X
X
9