Assembly - Husqvarna ST 430 Bedienungsanweisung

Battery safety
WARNING:
cause an explosion and cause injury.
If the battery has a deformation or
is damaged, speak to an approved
Husqvarna service agent.
WARNING:
instructions that follow before you use
the product.
• Use protective glasses when you are near
batteries.
• Do not wear watches, jewelry or other metal
objects near the battery.
• Keep the battery out of reach for children.
• Charge the battery in a space with good airflow.
• Keep flammable materials at a minimum
clearance of 1 m when you charge the battery.
• Discard replaced batteries. See
page 27 .
• Explosive gases can come from the battery. Do
not smoke near the battery. Keep the battery
away from open flames and sparks.
Safety instructions for maintenance
WARNING:
instructions that follow before you use
the product.
To remove the product from the
carton
1. Remove loose parts included with the product.
Cut the four corners of the carton and put the
end panels down flat.
2. Remove the two screws that attach the auger
housing to the pallet. Remove the steel brackets
from the skid plates if they have it.
3. Remove all package materials.
4. Remove the product from the carton and make
sure no loose parts are left in the carton.
Loose parts
(Fig. 30) Discharge chute (1)
(Fig. 31)
ON/OFF key (s)
(Fig. 32) Carriage bolts 5/16-18 x 2 ¼" (2)
(Fig. 33)
Chute retainer
14
A damaged battery can
Read the warning
Disposal on
Read the warning

Assembly

• The exhaust fumes from the engine contain
carbon monoxide, an odorless, poisonous and
very dangerous gas. Do not start the engine
indoors or in closed spaces.
• Before you do the maintenance on the product,
stop the engine and remove the ignition cable
from the spark plug.
• Use protective gloves when you do maintenance
on the blades. The blades are very sharp and
cuts can easily occur.
• Accessories and changes to the product that
are not approved by the manufacturer, can
cause serious injury or death. Do not change
the product. Always use accessories that are
approved by the manufacturer.
• If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
• Only do the maintenance as given in this
operator's manual. All other servicing must be
done by an approved service agent.
• Let an approved service agent do servicing on
the product regularly.
• Replace damaged, worn or broken parts.
(Fig. 34) Handle knobs (2)
(Fig. 35)
Locknut 3/8 (1)
(Fig. 36) Locknut 3/18-16 (1)
(Fig. 37) Shear pins ¼-20 x 1.81 (6)
(Fig. 38)
Locknuts ¼-20 (6)
(Fig. 39) Locknut 5/16-18 (1)
(Fig. 40) Locknut ¼-20 (1)
(Fig. 41)
Nylon washer (1)
(Fig. 42) Carriage bolt 5/16-18 x 5/8 (1)
(Fig. 43)
Roll pin (1)
(Fig. 44)
Release lever (1)
(Fig. 45) Discharge chute lever
876 - 016 - 11.03.2022