Husqvarna GX560 Bedienungsanweisung Seite 9

To set the handle position
1. Lift the hook (A).
B
2. Push the hook forward to set the handle in park
position (B).
3. Pull the hook rearward to set the handle in mow
position (C).
To start the product
1. Make sure that the ignition cable is connected to the
spark plug.
2. Set the handle in park position, see
handle position on page 8 .
3. Open the fuel valve.
4. Adjust the choke control.
a) If the engine is cold, set the choke control to the
choke position.
8
A
C
To set the
Автотовари «130»
b) If the engine is warm, set the choke control to the
operation position.
5. Hold the engine brake handle against the handlebar.
6. Put your right foot on the cutting cover.
7. Hold the top of the lower handle with your right hand
and tilt the product.
8. Hold the starter rope handle with your right hand.
9. Slowly pull out the starter rope until you feel some
resistance.
10. Pull with force to start the engine.
11. When the engine is at full speed, carefully lower the
product to the ground.
12. When the engine is warm, make sure that the choke
control is set to operation position.
13. Set the handle in mow position, see
handle position on page 8 .
WARNING: Do not twist the starter rope
around your hand.
To stop the product
• Tilt the product and release the engine brake handle.
• When the engine stops, lower the product.
• Set the handle in park position, see
handle position on page 8 .
• Close the fuel valve.
To get a good result
• Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
To set the
To set the
461 - 006 - 25.01.2019