Operation - EWT ECO15 Installations- Und Bedienungsanleitung

ELECTRICAL CONNECTION
WARNING THIS APPLIANCE MUST BE EARTHED
Assembly and Positioning
FITTING THE CASTORS
WARNING The radiator must only be operated with the
end, as shown in Fig.1.
other soft surface to avoid damage
Warning : The radiator is heavy – ensure that it is supported
to prevent it from toppling. Ask a second person to help with
this if necessary.
secure using the wing bolts (B). there are guides to ensure the
correct positioning and orientation of the caster plate.
Return the radiator to the correct orientation so it rests on the
castors. The product is now ready for use.
POSITIONING THE HEATER
Select the position for the heater ensuring there is clearance
heater and 150mm each side and 300mm from the control and
end panel. We recommend maximising the clearance where
possible.
Models & General Information
MODELS
Model Description
ECO15
Neon
ECO15C2A
& electro mechanical timer
ECO15C2B
& electronic 7 day timer
ECO20
Neon
ECO20C2A
& electro mechanical timer
ECO20C2B
& electronic 7 day timer
ECO25
Neon
ECO25C2A
& electro mechanical timer
ECO25C2B
& electronic 7 day timer
t t t t t t t t t t t t t t t tion nin ing
fo o o fo o o form mat ation n
Power
(W)
1500
1500
1500
2000
2000
2000
2500
2500
2500
GENERAL
The radiator is designed for operation on an AC electricity
supply, and is suitable for use in domestic dwellings and similar
indoor locations.
movement. A rotary selector switch provide the ability to
enables the room temperature to be controlled accordingly. It
is supplied with a cord and plug and is ready for use once the

Operation

IMPORTANT - OBJECTS OR CLOTHING MUST NOT BE
PLACED ON THIS HEATER.
Before using the heater ensure that all warnings and instructions
have been read carefully.
simply plug it in. Neon indicating lights (i, see Fig 2) located at
the controls area will illuminate when the appliance is plugged
into the mains. This indicates the appliance is energised and
ready for use.
CONTROLS (See Fig. 2 & 3)
Thermostat (T)
The Thermostat controls the heat output according to the room
temperature. This ensures that the heater will not produce heat
unnecessarily when the room is warm. To set the temperature
reached the desired temperature, turn the thermostat knob
now automatically operate at this temperature. The thermostat
also has a frost protection setting marked '
useful in areas such as garages, to prevent frost damage. If the
thermostat is set to its minimum setting '
5° to help protect against frost.
Note – Should the heater fail to come on when the thermostat
is at a low setting, this may be due to the room temperature
being higher than the thermostat setting.
Heat Selector Switch (S)
settings. The heat output can be altered to suit the application,
conditions and for improve the economy of operation.
Available output options are as follows:
Model O
ECO15(C2*)
ECO20(C2*)
ECO25(C2*)
'. This setting is
Switch setting
I II III
500W 1000W 1500W
600W 1400W 2000W
800W 1700W 2500W