Intended Use - Makita DTR180 Betriebsanleitung

Combination of 3 rebars
#3 (10 mm)
#4 (13 mm)
#5 (16 mm)
Combination of 4 rebars
#3 x #3 (10 mm x 10 mm)
#4 x #4 (13 mm x 13 mm)
NOTICE:
If there is a gap between rebars or if the tool is used at an incorrect orientation, the rebars may not be
able to be tied.
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
material!
In observance of the European Directives,
on Waste Electric and Electronic Equipment
and Batteries and Accumulators and Waste
Batteries and Accumulators and their
implementation in accordance with national
#3 x #3 (10 mm x 10 mm)
#3 x #3 (10 mm x 10 mm)
laws, electric equipment and batteries and
battery pack(s) that have reached the end of
their life must be collected separately and
returned to an environmentally compatible
recycling facility.

Intended use

The tool is intended for tying rebars.
Noise
The typical A-weighted noise level determined according
to EN60745-2-18 (EN12549):
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
WARNING:
Wear ear protection.
Vibration
The vibration total value (tri-axial vector sum)
determined according to EN60745-2-18 (ISO8662-11):
Work mode: Tying metal rod
Vibration emission (a
Uncertainty (K) : 1.5 m/s
13 ENGLISH
#4 x #4 (13 mm x 13 mm)
-
#4 x #4 (13 mm x 13 mm)
) : 78 dB(A)
pA
2
) : 2.5 m/s or less
h
2