Riester ri-thermo fastPRObe Gebrauchsanweisung Seite 48

Guidance and manufacture's declaration – electromagnetic emission
The ri-thermo
gnetic environment specified below. The customer of the user of the ri-thermo
fastPRObe Thermometer should assure that it is used in such an environment.
Emission test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
48
Warning!
Portable RF communications equipment (radios) including
accessories, such as antenna cables and external antennas,
should not be used in closer proximity than 30 cm (12 inches)
to parts and cables of the ri-thermo
specified by the manufacturer. Failure to comply may result in a
reduction in the device's performance features.
Directives and manufacturer's declaration - Electromagnetic
emissions
The ri-thermo
use in the electromagnetic environ¬ment specified below. The
customer or user of the ri-thermo
should ensure that it is used in such an environment.
fastPRObe Thermometer intended for use in the electroma-
®
Compliance
Group 1
Class B
fastPRObe Thermometer are intended for
®
Electromagnetic environment
– guidance
The ri-thermo
Thermometer uses RF energy
only for its internal function.
Therefore, its RF emissions
are very low and are not likely
to cause any interference in
nearby electronic equipment.
The ri-thermo
Thermometer is intended for
use in all establishments,
including residential areas and
those directly connected to
a public supply network that
also supplies buildings used
for residential purposes.
N / A
N / A
fastPRObe Thermometer
®
fastPRObe Thermometer
®
fastPRObe
®
fastPRObe
®
®