Initialisation - Koch PxtRX Betriebsanleitung

6 Operation
6.1
28
Operating manual PxtRX active energy management device
V1.1DE/EN

Initialisation

During the initialisation phase (the voltage supply was applied or the RESET button
was pressed) it is determined which other devices are still connected and which be-
comes master or slave.
By default, the device with the highest address becomes the master, while the de-
scending addresses determine the slaves. The address results from the serial number
of the device.
During initialization, the LEDs light up one after the other as follows:
Phase 1:
L1: Off
L2: lights green
Phase 2:
L1: lights red
L2: color change
blue / red / green / orange
Phase 3:
L1: Off
L2: Off
Phase 4:
L1: lights red
L2: flashes blue
Phase 5:
L1: Off
L2: lights up blue (if the device is the
master), otherwise lights magenta.
L3: Off
L4: Off
L3: lights green
L4: lights yellow
L3: Off
L4: Off
L3: Off
L4: Off
L3: Off
L4: lights yellow (when the switch-on
conditions (e.g. precharging) are com-
pleted), otherwise L1 lights red.