Installation - Z-EDGE Z3 Bedienungsanleitung

INSTALLATION

1. Insert the TF card into the TF/MicroSD card slot (10) on the camera.
2. Find an appropriate position on the windshield to attach the camera. A recommended
position to attach the camera is under the rear-view mirror. Please note:
a. This position should be close to the cigarette lighter (power) in the car to ensure
charging whilst recording.
b. This position should be clean so that the suction cup can attach to the surface firmly. If
not, please clean the surface using water if necessary and wait until dry.
c. This position should neither distract the driver nor block the driver's view whilst driving.
3. Turn the screw of the suction cup assembly into the threaded hole of the camera mount
(16) until securely attached.
4. Make sure the locking lever of the suction cup is pointing in the direction of the
camera - start position. Press and hold the suction cup against the windshield, pushing
the locking lever down (in the direction of the suction cup) until an audible click is heard.
The suction cup should now be securely attached to the windshield. To reposition or
remove the suction cup, pull the locking lever (in the direction of the camera) to release
suction, and pull away from the windshield.
5. Plug the car charger into the car
cigarette lighter, and connect to
the camera Micro USB port (8)
via the Micro USB cable.
For a more organized car
environment, the micro USB
cable can be routed as indicated
by the green dashed line in the
diagram.
6. Start the engine of your car. The
Z3 will automatically turn on
and start recording.
7. This device will detect when the
engine is switched off, and
automatically power off shortly
after the last video clip duration
is complete and saved.
- 4 -