Dometic Waeco COOLFREEZE CF-35 Bedienungsanleitung Seite 32

_CF-80_110.book Seite 32 Montag, 20. September 2010 10:40 10
Operation
Warning - Danger of damaging the device!
e
To avoid drops in voltage and therefore performance, keep the ca-
ble as short as possible and only disconnect it when necessary.
For this reason avoid additional switches, plugs or power strips.
Determine the required cross section of the cable in relation to
the cable length according to fig. 6, page 5.
Key for fig. 6, page 5
Co-ordinate axis
Warning - Danger of damaging the device!
e
Make sure that the polarity is correct.
Before starting up the device for the first time, check whether
the operating voltage and the battery voltage correspond (see
type plate).
Make sure that the cable at the positive battery terminal
(fig. 7 2, page 5) is protected with a 15 A fuse (fig. 7 3,
page 5).
Plug the 12/24-V connection cable (fig. 1 2, page 3) into the
DC socket on the cooler (fig. 7 1, page 5).
Connect the red cable (fig. 7 rt, page 5) to the positive terminal
of the battery (fig. 7 2, page 5).
Connect the black cable (fig. 7 sw, page 5) to the negative
terminal of the battery (fig. 7 2, page 5).
32
Meaning
l Cable length
∅
Cable cross section
Unit
m
mm²