Lamp Adjustment; Rigging - EuroLite TMH-150 Bedienungsanleitung

Procedure:
Step 1: Unscrew the fixation screws of the lamp cover and remove it.
Step 2: Unscrew the knurled-head screws of the lamp holder and remove it.
Step 3: If replacing the lamp, remove the old lamp from the lamp holder.
Step 4: Insert the lamp into the lamp holder.
Step 5: Replace the lamp holder and tighten the knurled-head screws.
Step 6: Adjust the lamp as described under lamp adjustment.
Step 7: Replace the lamp cover and tighten the fixation screws.

Lamp adjustment

The lampholder is aligned at the factory. Due to differences between lamps, fine adjustment may improve
light performance.
Strike the lamp, open the shutter and the iris, set the dimmer intensity onto 100 % and focus the light on a

Rigging

Please consider the EN 60598-2-17 and the respective national norms during the
installation! The installation must only be carried out by an authorized dealer!
The installation of the projector has to be built and constructed in a way that it can hold 10 times the weight
for 1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment. This secondary safety
attachment must be constructed in a way that no part of the installation can fall down if the main attachment
fails.
When rigging, derigging or servicing the fixture staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert before taking into operation for the first time and after changes before taking into operation another
time.
Do not operate this device with opened cover!
flat surface (wall). Center the hot-spot (the brightest
part of the beam) using the 3 adjustment screws "A,
B, C". Turn one screw at a time to drag the hot-spot
diagonally across the projected image. If you cannot
detect a hot-spot, adjust the lamp until the light is
even.
To reduce a hot-spot, pull the lamp in by turning all
three screws "A, B, C" clockwise ¼-turn at a time
until the light is evenly distributed.
If the light is brighter around the edge than it is in the
center, or if light output is low, the lamp is too far back
in the reflector. "Push" the lamp out by turning the
screws "A, B, C" counterclockwise ¼-turn at a time
the light is bright and evenly distributed.
DANGER TO LIFE!
23/58 51786400X51NXS_V_1_0.DOC