Setting The Date And Time; Attaching The Belt Clip - OpenScape DECT Phone S6 Base Bedienungsanleitung

Handset

Setting the date and time

Set the date/time so that the correct date and time can be assigned to incoming calls and to
enable the alarm to be used.
¤
Press the display key Time
or, if the date and time have already been set:
¤
. . . use
OK
The active cursor position flashes
with . . . switch between cursor positions with
Enter date:
¤
. . . using enter the day, month and year in 8-digit format.
Enter time:
¤
. . . using enter hours and minutes in 4-digit format.
Save settings:
¤
Press the display key Save. . . . Saved is shown in the display and
a confirmation tone sounds.
Return to idle status:
¤
Press and hold the End call key
The telephone is now ready for use.

Attaching the belt clip

The handset has notches on each side for attaching the belt clip.
•
Attaching the belt clip:
handset so that the tabs on the belt clip click into place in the
notches.
•
Removing the belt clip:
with your right thumb.
between the clip and the casing.
remove.
Professional belt clip (accessory)
Attaching the belt clip:
¤
Press the holder on the back of the handset so that the tabs click
into place in the notches
¤
Secure the belt clip on the belt
¤
Hook in the handset with holder into the belt clip
it down .
4
10
to select Settings
. . . change cursor position
Press the belt clip onto the back of the
Press the centre of the belt clip firmly
Push the nail of your left thumb up
Slide the clip upwards to
.
1
.
2
OK Date/Time
and push
3
Calls Time
Date/Time
Date:
15.08.2021
Time:
00:00
Back Save
1