Herunterladen Inhalt Inhalt Diese Seite drucken

Manufacturer's Advice; Contact With Liquid - OpenScape DECT Phone S6 Base Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Manufacturer's advice

Manufacturer's advice
Authorisation
We, Unify Software and Solutions GmbH & Co. KG, declare that this device type OpenScape DECT Phone S6
meets the essential requirements and other relevant regulations laid down in Directive 2014/53/EU.
The EC declaration can be found in the Unify Expert WIKI at
http://wiki.unify.com under the section "Declarations of Conformity".
Care
Wipe the device with a damp cloth or an antistatic cloth. Do not use solvents or microfibre cloths.
Never use a dry cloth; this can cause static.
In rare cases, contact with chemical substances can cause changes to the device's exterior. Due to the wide
variety of chemical products available on the market, it was not possible to test all substances.
Impairments in high-gloss finishes can be carefully removed using display polishes for mobile phones.

Contact with liquid

If the device comes into contact with liquid:
1
Disconnect the power supply.
2
Remove the batteries and leave the battery compartment open.
3
Allow the liquid to drain from the device.
4
Pat all parts dry.
5
Place the device in a dry, warm place for at least 72 hours (not in a microwave, oven etc.) with the battery
compartment open and the keypad facing down (if applicable).
6
Do not switch on the device again until it is completely dry.
When it has fully dried out, you will normally be able to use it again.
58

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis