Features; Special Features - Bosch Rexroth PSI 6 373 Serie Typspezifische Anleitung

34/39 Bosch Rexroth AG

Features

7 Features
Sequence standard 1000 Hz (sequence parameters in milliseconds)
I/O-board: E/A-IBS_XFERN_8/8
(Details refer to Tab1. Required and supplementary documentation,
Rexroth PSI6xxx Weld Timer with Medium-Frequency Inverter Instructions).
7.1

Special features

The welding controller features the following specifics:
• Control is prepared for a networking with an Interbus - PMS or Professional Bus
cbm or ethernet assembly.
• Control is prepared for the control system PSQ6000 XQR.
From firmware version -202: Rewelds aren´t done in UIR-mode, but in KSR- or
PHA-mode (regarding measuring, regulation, supervision and stepper).
KSR-supervision is further active, if UI-supervision without UI-regulation is
programmed.
• The Control has 4 electrodes.
A sequence with electrode "1" will turn on the output "Gun 1 active".
A sequence with electrode "2" will turn on the output "Gun 2 active".
A sequence with electrode "3" will turn on the output "Gun 3 active".
A sequence with electrode "0" will not change the "Gun active" outputs.
The output will remain on until the next start sequence is received.
• New Tip dress functionality
An active „tip dress request" can be reset with the input „tip dress acknowledge"
There exist an alternative possibility:
With the activation of program 61 the tip dress request for electrode 1 is
-
automatically acknowledged and the dress counter is incremented.
With the activation of program 161 the tip dress request for electrode 2 is
-
automatically acknowledged and the dress counter is incremented.
An active „start tip dress request" can also be reset with the input „tip dress
acknowledge"
There exist a alternative possibility:
With the activation of program 62 the start tip dress request for electrode 1
-
is automatically acknowledged.
With the activation of program 162 the start tip dress request for electrode
-
2 is automatically acknowledged.
The user has to take care for the necessary welding parameters in the
programs 61, 62, 161, 162 as they are dress programs only
From firmware version -202: The automatic acknowledgement with the
activation of the programs 61, 62, 161 und 162 will be disabled if the input "Tip
dress programs off" is set.
R911172831 | PSI 6xxx.373