Mounting And Installation Of The Tank - hajdu SMILEY SY80R Montage- Und Gebrauchsanleitung

SY80R • SY120R • SY150R

4. MOUNTING AND INSTALLATION OF THE TANK

The mounting of the hot water container, as well as its connection to the
water and electrical network and commissioning must be performed by
a qualified professional according to our instructions and observing the
In case of improper connection and installation, you
At the installation location, suitable electri-
cal and water supply and sewage system
must be ensured, and before mounting, the
structure of the wall must also be checked
by an architect for compliance.
We recommend the following solutions
for mounting the appliance:
• For stone, brick or concrete wall of
100–150 mm thickness:
50x5 mm hexagonal
(MSZ4342/DIN1017)
on the other side of the wall with flat steel
reinforcement. From the rear side, hex-
agonal through bolts (M12 8 .8, ISO 4017/
DIN933) and wood construction washers
(M12, DIN440R), and from the appliance
side, M12 nuts (DIN934) and washers (A13,
DIN125) should be used.
• For thin walls:
On the rear side of the wall, vertically
placed 60x30x6 mm U shaped steel profile
(MSZEN 10279/ DIN1026) should be used
for reinforcement. From the rear side, hex-
agonal through bolts (M12 8 .8, ISO4017/
DIN933) and washers (A13, DIN125), and
from the appliance side, M12 nuts (DIN934)
and washers (A13, DIN125) should be used.
32 2
standards IEC 60364 / MSZ HD 60364.
will lose all your guarantee and warranty rights!
The tank must be installed and operated
in a frost free environment.
through
placed horizontally
bolts
Figure 4.1.-1