Electrolux KGG95375K Benutzerinformation Seite 21

Problem
The flame extinguishes im‐
mediately after ignition.
The flame ring is uneven.
The control panel bright‐
ness is reduced or it
switches off.
The control knob pilot
lights turn on after con‐
necting the hob to the
mains or after a power out‐
age.
Hob²Hood function does
not work.
You cannot activate or op‐
erate Hob²Hood and Mi‐
nute Minder.
The display shows "E t"
does not shows up
when knobs are opened.
8.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Make sure,
you operated the hob correctly. If not the
servicing by a service technician or
Possible cause
Burner cap and crown are
placed incorrectly.
Thermocouple is not heat‐
ed up sufficiently.
Burner crown is blocked
with food residues.
The temperature of the
plate is high. To ensure
long lifetime of the display
the brightness is reduced
depending on the tempera‐
ture of the hob. Above a
certain temperature the
control panel switches off.
Pilot light test.
You covered the control
panel.
There is water or fat stains
on the control panel.
-
Selected Automatic Mode
is A0.
dealer will not be free of charge, also
during the warranty period. The
instructions about the Service Centre
and conditions of guarantee are in the
guarantee booklet.
ENGLISH
Remedy
Place the burner cap and
crown correctly.
After lightning the flame,
keep the knob pushed for
equal or less than 10 sec‐
onds.
Make sure that the injector
is not blocked and the
burner crown is clean.
Let the hob cool down.
Refer to "Installation".
Remove the object from
the control panel.
Clean the control panel.
Turn off the control knobs
and wait until the display is
off or disconnect the appli‐
ance to the main to return
to the initial condition.
Refer to "Daily use".
21