Caliber mcd 893 Bedienungsanleitung Seite 8

Tasks
Start using MCD893
When MCD893 is started the first time, you need to do the following:
1. Select the written language of the application. Later you can change it in Settings.
2. Select the language and speaker used for voice guidance messages. Later you can
change it in Settings.
3. Select whether to start the program in Simple mode or in Advanced mode. Later you
can switch between the two operating modes in Settings.
After this, the Navigation menu appears and you can start using MCD893.
The Navigation menu in Simple mode:
The Navigation menu in Advanced mode:
The typical way of using MCD893 is to select a destination, and start navigating. You can
select your destination in the following ways (not all of them are available in Simple mode):
•
Use the selected location on the map (the Cursor).
•
Enter a full address or a part of an address, for example a street name without a house
number or the names of two intersecting streets.
•
Enter an address with postal code. This way you do not need to select the name of the
settlement and the search for street names might be faster as well.
•
Use a coordinate
•
Use a saved location:
•
a Favourite
•
a POI
•
the History of previously set destinations and waypoints
bottom right corner to the bottom left corner on any screen.
•
Shortcut to open the Navigation menu: slide your finger from
the top left corner to the bottom left corner on any screen.
Instructions
7