Caliber mcd 893 Bedienungsanleitung Seite 58

Name
If you tap the previous button, this one replaces
it.
Most of the fields on this screen have a
the field it is attached to is shown on the map as a Trip Data. It also shows the position of the
data as follows:
Symbol
4.1.7.1 Trip Computer screen
The Trip Computer screen provides collected trip data. It can be opened from the Trip
Information screen by tapping
The fields on this screen are continuously updated while you keep the screen open.
You can switch between the trips, pause then resume them, or reset their data.
You have the following functions on this screen:
Name
Pauses the trip currently shown on the screen. Values on the screen stop
changing.
This button replaces the previous one if it has been activated. Tap it to
resume collecting trip data.
Resets all counters of the currently shown trip. Collecting trip data is
restarted only when MCD893 receives a position from the GPS.
Cycles through all trips.
,
Description
symbol next to them. This symbol shows whether
This value is not shown on the map screen.
This value appears on the map screen in the Trip Data area. This is
the value at the top.
This value appears on the map screen in the Trip Data area. This is
the value in the middle.
This value appears on the map screen in the Trip Data area. This is
the value at the bottom.
.
Tap this button and the
Route Data fields show
information about the final
destination again.
Description
Description
Function
57