Caliber mcd 893 Bedienungsanleitung Seite 54

Button Description
Displayed at the Cursor if it is at the same location with which the
Cursor menu was opened.
Displayed at the Cursor if it has been relocated since the Cursor
menu was opened.
Opens a new screen with the address and coordinate of the Cursor,
and the list of nearby POIs.
Opens the full-screen Cursor menu with all the possible options.
A new route is calculated with the Cursor as the destination. The
previous route is deleted.
If the Cursor is at or near the destination, this button replaces the
previous one, and deletes the current destination from the route. The
last via point is promoted as destination, or if there are no via points,
the route is deleted.
The Cursor is added to the active route as an intermediate route
point, a point to be reached before the destination. If there is already
a via point in the route, the Edit Route screen opens to let you
decide where the new via point is to appear in the route.
If the Cursor is at or near one of the via points, this button replaces
the previous one, and deletes the selected via point from the route.
The route is recalculated without the deleted point.
The Cursor is appended at the end of the route as the new
destination. The previous destination is demoted, and becomes the
last via point.
This button is similar to the button, but a new
screen opens, and the route is calculated with all the possible route
calculation methods (Fast, Short, Economical and Easy). Observe
the results, and choose one of the routes to navigate.
The Cursor becomes the start point of the route. This means that the
route will not be started from the current GPS position, and
Automatic Off-route Recalculation needs to be turned off to keep the
start point the selected one.
If the Cursor is at or near the selected start point, this button
replaces the previous one, and deletes the start point from the route.
The current GPS position is used again as the start point, and
Automatic Off-route Recalculation is re-enabled.
The Cursor is saved as a user POI. Select the POI group and give a
name for the POI, then select a suitable icon, enter a phone number,
and additional information if you like.
Map locations can be marked with Pins. Unlike POIs, a Pin has no
name and other details, only a colour to let you tell one from another
on the map.
If the Cursor is at or near a Pin, this button replaces the previous
one, and deletes the Pin the Cursor is near to.
The Cursor is saved as the location of a Road Safety Camera
(speed camera or red light camera). A new screen appears where
you can set the type of the camera, the direction of the measured
traffic, and the speed limit checked (if applicable).
If the Cursor is at or near a Road Safety Camera, this button
replaces the previous one, and opens a new screen where you can
edit the details of the camera.
53