Caliber mcd 893 Bedienungsanleitung Seite 69

Button
Master Volume
Voice Guidance Volume
Key Sounds
Dynamic Volume
4.5.3 Route Planning options
These settings determine how routes will be calculated. Tap the following buttons:
,
Button
Vehicle
Road Types Used
Route Planning
Route Calculation Method
68
Use the switch to mute all sounds of the device and then to re-
enable them again. The position of the fader determines the
volume level.
The loudness of MCD893 is independent of your device settings.
When you exit the program, the device default settings return.
The slider adjusts the loudness of voice prompts. In its leftmost
position, the voice guidance is suppressed; in its rightmost
position, the master volume applies.
Key sounds are audible confirmation of either pressing hardware
buttons or tapping the touch screen.
The switch turns the key sounds on or off. Key sounds are
played at the master volume level.
When driving at high speed, the noise in the car may be too loud
to clearly hear the voice guidance and other sounds. Using
Dynamic Volume you can instruct MCD893 to increase the
volume when your speed exceeds a certain minimum, and reach
its highest volume at the given maximum speed.
.
You can set the type of vehicle you will use to navigate the
route. Based upon this setting, some of the road types will be
excluded from the route (e.g. motorways for pedestrians), or
some of the restrictions may not be taken into account (e.g.
emergency vehicles have only a few restrictions).
for
To let the route fit your needs, you can also set which road types
are to be considered for or to be excluded from the route, if
possible.
Excluding a route is a preference. It does not necessarily mean
total prohibition. If your destination can only be accessed using
some of the excluded road types, they will be used, but only as
much as necessary. In this case a warning icon will be shown on
the Route Information screen, and the part of the route not
matching your preference will be displayed in a different colour
on the map.
You can choose from different route types. The routing method
can also be chosen while creating the route: when the
destination is selected, tap
menu.
Description
Description
,
in the Cursor