Caliber mcd 893 Bedienungsanleitung Seite 37

3.1.4 Selecting the destination from the POIs
You can select your destination from the POIs included with MCD893 or from the ones you
have previously created.
The procedure is explained starting from the Navigation menu.
1. Tap the following buttons:
mode).
2. Select the area around which the POI should be searched:
•
: The POI will be searched around a given address.
•
: The map appears with the Cursor in the middle. Modify the location of
the Cursor if necessary, then tap
the given location.
•
•
route.
•
size of the detour it means from the active route. This can be useful if you
search for a later stopover that causes only a minimal detour. For example
upcoming petrol stations or restaurants.
3. You can narrow the search with the following:
•
Select the POI group (e.g. Accomodation), and after that, if needed, select the
POI subgroup (e.g. Hotel or Motel).
•
To find the POI by its name, tap
part of the name.
•
To list all POIs in a given POI group, tap
4. [optional] When finally the list of results appear, you can sort the list:
•
single location)
•
line (available when you search around a single location)
•
: sort the list by the distance to drive on route from your current position
(available when you search along the active route)
36
: The POI will be searched around the current GPS position.
: The POI will be searched around the destination of the active
: The POI will be searched not around a given point but by the
: sort the list alphabetically (available when you search around a
: sort the list by the distance from your current position in a straight
(Simple mode), or
. The POI will be searched around
, and use the keyboard to enter a
, (Advanced
.