ASROCK ALIVENF6P-VSTA Handbuch Seite 14

2.6 Onboard Headers and Connectors 2.6 Onboard Headers and Connectors 2.6 Onboard Headers and Connectors
2.6 Onboard Headers and Connectors 2.6 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper
caps over the headers and connectors will cause permanent dam-
age of the motherboard!
•
Floppy Connector
(33-pin FLOPPY1)
(see p.2 No. 18)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Blue)
(39-pin IDE1, see p.2 No. 7)
connect the blue end
to the motherboard
Note: Please refer to the instruction of your IDE device vendor
Serial ATAII Connectors
(SATAII_1 (PORT0): see p.2, No. 11)
(SATAII_2 (PORT1): see p.2, No. 12)
(SATAII_3 (PORT2): see p.2, No. 13)
(SATAII_4 (PORT3): see p.2, No. 14)
-
Serial ATA (SATA)
Data Cable
(Optional)
Serial ATA (SATA)
Power Cable
(Optional)
connect to the SATA
HDD power connector
1 4 1 4 1 4
1 4 1 4
ASRock
80-conductor ATA 66/100/133 cable
These four Serial ATAII (SATAII)
connectors support SATAII
SATAII_1 (PORT0)
or SATA hard disk for internal
storage devices. The current
SATAII_2 (PORT1)
SATAII interface allows up to
SATAII_3 (PORT2)
3.0 Gb/s data transfer rate.
SATAII_4 (PORT3)
Either end of the SATA data cable
can be connected to the SATA /
SATAII hard disk or the SATAII
connector on the motherboard.
Please connect the black end of
SATA power cable to the power
connector on each drive. Then
connect the white end of SATA
connect to
power cable to the power
the power
connector of the power supply.
supply
ALiveNF6P-VSTA Motherboard
the red-striped side to
Pin1
connect the black end
to the IDE devices
for the details.