Closing The Door; Installation; Electrical Connection - Electrolux EUN2243AOW Benutzerinformation

30 www.electrolux.com
Problem
DEMO appears on
the Display.

6.1 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to

"Installation".

7. INSTALLATION
7.1 Positioning
WARNING!
If you are discarding an old appli-
ance that has a lock or catch on
the door, you must ensure that it
is made unusable to prevent
young children being trapped in-
side.
The appliance shall have the plug
accessible after installation.
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Cli-
mate
class
SN
N
ST
Possible cause
The appliance is in dem-
onstration mode (DEMO).
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
Solution
Keep pressed approximate-
ly 10sec the Mode button
since a long sound of buz-
zer is heard and the Display
shut off for a short while:
appliance start works regu-
larly.
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
Cli- Ambient temperature
mate
class
T +16°C to + 43°C

7.2 Electrical connection

Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic power
supply.
The appliance must be earthed. The pow-
er supply cable plug is provided with a
contact for this purpose. If the domestic
power supply socket is not earthed, con-
nect the appliance to a separate earth in
compliance with current regulations, con-
sulting a qualified electrician.
The manufacturer declines all responsibili-
ty if the above safety precautions are not
observed.
This appliance complies with the E.E.C.
Directives.