Safety Measures; Before Starting - SPERONI TSN 20 Bedienungsanleitung

SUBMERSIBLE PUMP

1. Safety measures

Carefully read the operating instructions before assembling
and starting. The appliance must not be used by persons
who are not thoroughly acquainted with the instructions
handbook (operating instructions) Children and persons
under the age of 16 cannot use the pump and must be
kept well away from the appliance when it is conne ted.
The user is liable towards third parties in the area where
the appliance is in operation.
While the pump is operating persons must
not be in the liquid to be pumped.
The pump may be connected only by
means of a safety switch for fault currents, with
a rated opening current up to 30 mA and a socket
with an ea th contact installed in confo mity with
the regulations.
Protection: at least 10 Amps.
Operation in swimming pools and garden ponds is
admitted.
For other operation, the provisions in conformity with
the standard VDE 0100 part 702 must be respected.
CAUTION: Before checking, connect the pump and
the system with no voltage!
Replacing the line connecting up with the mains
requires using special tools and therefore may be
done only by the manufacturer or its service engineers.
The pump may operate only with a pipe connecting
the appliance (extension) that is no lighter than a
rubber hose mod. H07 RNF in conformity with the D N
57282 or D N 57245 standard.
(For your safety)
The voltage (230 Volts alternating current) indi-
cated on the pump's rating p ate must correspond
to the avai able mains voltage.
Before starting it is necessary to make sure by having a
check made by qualified personnel tha there are the
necessary lectrical protection measures.
The safety switch for fault currents corresponds to the
safety regulations of th electr city board and functions
perfectly.
Plug connections must be prote ted from water If there
is a r sk of flooding, plug connections must be placed
somewhere safe.
Definitely avoid pumping aggressive liquids and abrasive
products.
In the event of the pump failing, repair work may only be
carried out by the repair workshops of the technical
service Only genuine spare parts must be used.
It is notified that in conformity with the law on product
liability
we cannot be held responsible
for the damage caused by our appliance:
a) because of improper repairs not carried out by the
personnel of the ass stance points authorized by us;
b) or if GENU NE SPARE PARTS are not used to replace
parts;
c) or if the indications and prov sions given in the instruc-
tions handbook are not complied with.
The same provisions hold for the accessories.
Resistance
The maximum temperature of the delivery liquid should
never exceed +35 C in continuous operation.
Infiammable, combustible or explosive liquids cannot
be conveyed with this pump!
In particular, do not use engine fuels, dete gents, or other
chemical products.
2. Use
CAUTION! Sector of use
"DRAINAGE" – To transfer and empty fresh to
sl ghtly pol uted water from rainwater barrels and
casks.
"VORTEX" – Portable submers ble pump for
discharge and waste water with solids in suspen-
sion.
Also used as eme gency pump, in case of over-
flowing with muddy water, thanks to its large
suction filter.
To achieve excellent motor cooling the pump
casing is provided with a breather hole that enables
water to flow out.
The pump must be protected from running dry.
Starting
First put the pump into water and then
connect the plug.
The pump is ready for use.

3. Before starting

Instal ation of your canned motor pump is:
Take care
When installing t is necessary to take care that the pump
is never fitted hanging from its delivery ipe, but is always
placed in a raised position with respect to the bottom of
18