Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation
Step 1
Step 2
Minimum distance
Seal the pipe threads (A) with
liquid seal.
Mount the unit in direction of the
flow (arrow)*. Screw the pipes
into the adapters (B) and tighten
them. Tightening torque: 30 Nm.
Block the adapters by means of a
spanner. Do not turn the 2
adapters (B). This would lead to a
faulty sealing inside the housing.
To avoid malfunction a minimum
distance (5 x pipe diameter)
between the flow monitor and
bends, valves, changes in cross-
section or such like must be
observed
(This information refers to lami-
nar flow).
*For certain mounting positions (unit
vertical, flow direction horizontal) air
bubbles in the system can affect the
measurement after mounting. Briefly
rinse the system after mounting (rinse
flow rate > 3 l/min.).
A
SP1
SP2
Mode/Enter
Set
A
B
SP1
SP2
Mode/Enter
Set
B
SP1
SP2
Mode/Enter
Set
Page 21
Werbung
Inhaltsverzeichnis
