Silvercrest SND 3600 A2 Bedienungsanleitung Seite 75

Handling and operation
♦ Slide the holder with the negatives and/or slides to be scanned
into the slot
The scan motif will be displayed in the preview fi eld .
NOTICE
► A holder that has been inserted into the device cannot be pulled
out again, it has to be pushed completely through the device.
♦ Adjust the holder, if required, until the scan motif is displayed
optimally in the preview window.
♦ If necessary, you can set the electrical balance (Balance), the
exposure (Exposure), the brightness (Brightness), the contrast
(Contrast) and the saturation (Saturation) by pressing on the
button
A settings window will be opened.
♦ Click on
decrease the corresponding value.
Use the slide controller to adjust the electrical balance (Colour
balance).
Example: If the image has a too high proportion of blue, this can be
reduced by increasing the yellow component.
SND 3600 A2
on the device until it locks into place.
3
"Adjust".
to increase the corresponding value and on
GB
to
71