Installation - Klarstein Contempo 10033470 Bedienungsanleitung

EN
26

INSTALLATION

Preparation
If you have an outlet to the outside, your cooker hood can be
connected as below picture by means of an extraction duct
(enamel, aluminium, flexible pipe or inflammable material
with an interior diameter of 150 mm).
• Before installation, turn the unit off and unplug it from the
outlet.
• The cooker hood should be placed at a distance of
65-75 cm above the cooking plane for best effect.
Installation (Vent outside)
Note: When the range hood and appliance supplied with energy other than
electricity are simultaneously in operation, the negative pressure in the room must be
not exceed 4 Pa (4 x 10-5 Bar).
Installation method 1: Wall mounting
• To install onto the wall drill 2 holes of 8 mm on a suitable place according with the
centre distant of hole in the back of the cooker hood.
• Insert the nut into the holes.
• Insert the screws into the nuts and tight. Put the cooker hood onto the tighten screws.
• Fix the cooker hood with safety screws. The two safety vents are positioned on the
back casting, with diameter of 6 mm.
• Put the one way valve onto the cooker hood.