AEG HC652600EB Benutzerinformation Seite 27

6. Loosely turn in fixing plates from below on the worktop and on the connection bar.
7. Put the subsequent appliance in the worktop cut out . Make sure that the front ends
of the appliances are on the same level.
8. Tighten the fixing plate / retaining grip screws.
9. Seal the gap between the worktop and appliances and between appliances with sili-
cone.
10. Put some soapy water on the silicon.
11. Press the rubber shape with some strength against the glass ceramic and move it
slowly along the space.
12. Do not touch the silicon until it become hard, it can last about a day.
13. Carefully remove silicon that came out with a shaving blade.
14. Clean glass ceramic fully.
Installation instructions
27