Setting - Gastrodomus 6PFRE05 Bedienungs- Und Wartungsanleitung

2.2 SETTING

A
A = Illuminated main switch
B = Electronic regulator
Energizing the appliance:
1.
Connect the appliance with the main switch installed before it .
Switch on the appliance:
2.

Press the switch (A) to position I.
Note:
Up the instrument (B) carries out a self diagnostic in this sequence:
a. The display shows "888" flashes for 3 seconds
b. The display shows "rI.4" (firmware loaded into the instrument) for 3 seconds
c. At the end of the display shows "Stb" (stand-by)which alternates with the temperature reading.
Setting the desired temperature (tool B):
3.

To make the cooking temperature you want, press the button 2 (the display shows "SP1") press again button
2, it appears the set temperature. Use the buttons 2 and 3 to change the value of the desired temperature..

To store the new value, press once the button 1 (P), or wait for 15 seconds at the end of which the instrument
automatically stores the set temperature.
Start cooking cycle:
4.

To start a cooking cycle, press 4 (U) for 2 seconds.
Automatically lights up the LED Out1 (heating operation). Wait until the display is the temperature read is
equal to the set temperature..
End of cooking cycle:
5.

To turn off the heater, press the button for two seconds 4 (U), the LED Out1 will turn off. The display shows
"Stb" which alternates with the temperature reading .
B
Pag. 11